Epson ActionLaser 1000 Setup Manual page 17

7. Next you reset the TONER setting. Three messages flash in
rotation on the display:
NEW CARTRIDGE?
YES, PRESS RESET
NO, PRESS CONTINUE.
8. Press RESET to change the TONER setting to full.
9. Gently press down on the printer cover until it clicks shut.
Please note: If you replace the cartridge when more than 20%
toner is left, the three rotating messages do not appear. Instead
COVER OPEN E**
SelecType Level 2 TONER option to change the TONER setting
to full.
If you do not change the TONER setting to full after replacing
the imaging cartridge, the TONER message indicates the wrong
amount of toner left.
the toner level is full.
Note:
Each time you replace the imaging cartridge, you should print a
feature print to be sure the print quality is satisfactory and that you
installed the cartridge properly. See "Test printing" earlier in this
guide.
14 Maintenance
or more asterisks) appears. Use the
F (two
Also NEW CARTRIDGE?
appears even if