Bauer 20115E-B Owner's Manual & Safety Instructions page 11

Feeding nylon Line
nOticE: to prevent damage to trimmer,
DO nOt BuMp SpOOL HOuSinG On GrOunD.
this string trimmer feeds Line automatically
when stopping and restarting.
1. With Trimmer running, release Trigger
and allow Trimmer to stop fully, then press
Trigger to restart. Line will be fed out and
cut to proper length by Line Cutter.
2. If Trimmer is not cutting correctly, Spool may
be tangled. Remove Spool and rewind Line.
replacing nylon Line
1. Press tabs on Spool Cover, remove Spool Cover,
then remove Spool from Spool Housing.
Spool
cover
2. Remove old line from Spool.
3. Clean interior of Spool Housing with soft cloth.
4. Insert end of Nylon Line (up to 16 feet)
into Line Insertion Hole.
Line insertion
Item 57610
Hole
For technical questions, please call 1-888-866-5797.
3. To manually feed Line, unplug the Power Cord,
press the Line Outlet Button on Spool Housing,
and pull out the Line slightly. Keep pushing
the Button and pulling the Line out until
the Line reaches the desired length.
Spool
Housing
Line Outlet
5. Wrap Line onto Spool in neat, straight rows, under
tension, following arrow direction on top of Spool.
6. Leave approximately 4" of line unwound and
insert it into the cleat at the top end of Spool.
Then repeat for the lower end of Spool.
7. Insert Spool partway into Spool Housing,
insert line ends through Line Outlet in
housing, and pull line ends snug.
8. Insert Spool fully and replace Spool Cover.
Button
cleat
14
Line
Outlets
Page 11