Table of Contents
Advertisement
TO RECORD A MESSAGE ON STAGE 1 USING THE ON-BOARD MICROPHONE
For Stage 1:
Set dip switch S2 positions 2,3
& 4 to 'ON', all others to 'OFF'
For Stage 2:
Set Switch 'S2' positions 3 & 4
to 'ON'; all others to 'OFF'
1
For Stage 3:
Set Switch 'S2' positions 2 & 4
to 'ON'; all others to 'OFF'
For Stage 4:
Set Switch 'S2' positions 4 to
'ON'; all others to 'OFF'
Switch on power or
2
Press reset button
Press and release action button:
3a
Start recording
Speak into the on-board
microphone (MIC)
It is suggested that a 2" (5cm)
gap be maintained to the
microphone.
3b
The peak detector LED should
flash regularly to maintain a
good recording level.
However, if it stays on for most
of the time, the recording may
be distorted.
Press action button:
4
Stop recording
TO RECORD FROM LINE-IN JACK (J3) INSTEAD OF THE ON BOARD MICROPHONE:
•
Ensure that the audio cable is connected from the message source to jack J3 before
recording.
•
Follow above step 1 but set Switch 'S2' position 4 to 'OFF' for each stage.
•
At step 3b, play recording from message source. You will be able to listen as it is
recorded.
IMPORTANT NOTE
After the unit is configured, it must be put into its Playback Mode to operate.
•
Set switch S2 to stage 1, as shown in Playback Mode chart (next page).
RECORD MODE
(NOTE: "Black" color indicates "ON" position)
7
TA
ON
R/E
RA
TA
RA
ON
R/E
TA
RA
ON
R/E
TA
R/E
RA
ON
PEAK
TA
ON
R/E
RA
Advertisement
Table of Contents
