H3C S10500X Series Configuration Manual page 17

•
LSUM1TGS48RSH0 interface modules: all 10-GE interfaces.
•
LSUM1TGS48SH0 interface modules: all 10-GE interfaces.
Set the duplex mode to full and speed to 1000 Mbps for both the local interface and the peer inter
when a 25-GE interface has a 1-Gbps transceiver module installed on the following interface
modules:
•
LSUM1YGS24CSSH0 interface modules.
•
LSUM1YGS48XSH0 interface modules.
The last eight 10-GE interfaces on the LSUM1TGT24FD0 interface module support only the speed
higher than 100 Mbps. The system prompts this interface speed restriction when you configure an
unsupported speed.
Configuration procedure
Step
1. Enter system view.
2. Enter Ethernet interface
view.
3. Set the description for
the Ethernet interface.
4. Set the duplex mode for
the Ethernet interface.
5. Set the speed for the
Ethernet interface.
6. Set the expected
bandwidth for the
Ethernet interface.
7. Restore the default
settings for the Ethernet
interface.
8. Bring up the Ethernet
interface.
Command
system-view
interface interface-type
interface-number
description text
duplex { auto | full | half }
speed { 10 | 100 | 1000 | 2500 |
|
5000 | 10000 | 25000 40000 |
100000 | auto }
bandwidth bandwidth-value
default
undo shutdown
8
Remarks
N/A
N/A
The default setting is interface-name
Interface.
Fiber ports do not support the half
keyword.
By default, the duplex mode is auto for
Ethernet interfaces.
For interfaces at two ends of a physical
link to operate correctly, configure the
same duplex mode for them.
Interfaces that operate in 1000 Mbps or a
higher speed do not support the half
keyword and cannot autonegotiate the
half duplex mode with the peer.
By default, an Ethernet interface
autonegotiates the speed with its peer.
Support for the keywords of this command
varies by interface type. For more
information, execute the speed ?
command in interface view.
For interfaces at two ends of a physical
link to operate correctly, configure the
same speed for them.
The speed of a 10-Gbps or faster fiber
port cannot be configured or
autonegotiated as 100 Mbps or lower.
By default, the expected bandwidth (in
kbps) is the interface baud rate divided by
1000.
N/A
B y default, an Ethernet interface is up.
The shutdown, port up-mode, and
loopback commands are mutually
exclusive.