Page 1
FRIWAC Series Electronically controlled domestic fresh water unit Installation and operating manual (translated from the original operating manual) WattsWater.eu...
ENGLISH Content 1 General information 1 General information ........2 1.1 Important notes about the Installation and Operating Manual 1.1 Important notes about the Installation and Operating Manual ..2 1.2 Product conformity ............2 NOTICE The operator is responsible for ensuring adherence to the local laws and regulations (e.g.
2.3 Intended use Operators The FRIWAC Series domestic freshwater unit is intended for An operator is deemed to be qualified if they have read domestic hot water generation. It uses the instantaneous...
ENGLISH 3 Technical features Hydraulic data Max. operating pressure 10 bar Ambient temperature -2 °C to +40 °C (observe pump specifications) Operating temperature +2 °C to +90 ° (observe pump specifications) Temperature setting range controller 30 - 85 °C Pre-setting controller Tnom = 50 °C FRIWAC WT26: 5 - 25 l/min;...
ENGLISH 7 Component overview Fig. 7-1: FRIWAC domestic fresh water unit component overview Controller mounting plate (foldable for pump maintenance) Heating supply primary circuit 1” union nut Plate heat exchanger Heating return primary circuit 1” union nut Flow sensor with temperature sensor Hot water outlet secondary circuit 1”...
ENGLISH 8 Installation and commissioning 8.1 Installation Tightening torques for screw fittings 1" 55 Nm DANGER Electricity! ! CAUTION Danger of material damage. Risk of death from electric shock! The domestic fresh water unit is not protected against water h Work on live parts must be carried out only by trained splashes or drops.
ENGLISH • Observe Fig. 8-3 for steps 4 to 7. Secondary circuit 4. Insert the wall plugs (item 1). 5. Screw the hanger bolts (3) into the wall plugs. 6. Fit the wall bracket (item 2). 7. Locate the domestic fresh water unit vertically on the wall. Ø...
ENGLISH 9 Maintenance 9.2 Replacing wear parts Note that the domestic fresh water unit has parts which are subject to wear that naturally occurs as a result of normal use DANGER Electricity! even when properly maintained and serviced. Risk of death from electric shock! Specifically, these are mechanical parts and parts which are in h Maintenance work on the domestic fresh water unit may only contact with hot water and steam such as hoses, seals, valves,...
The descriptions and photographs contained in this product specification sheet are supplied by way of information only and are not binding. Watts Industries reserves the right to carry out any technical and design improvements to its products without prior notice.