Related Manuals for Alumax SPEEDSTALL 794S Series
Summary of Contents for Alumax SPEEDSTALL 794S Series
- Page 1 INSTALLATION INSTRUCTIONS SERIES SPEEDSTALL SHOWER ENCLOSURE G03711103 Copyright © Alumax Bath Enclosures 1997. All rights reserved. Page 1 of 9 8-22-06...
- Page 2 INSTALLATION WARNINGS Alumax Bath Enclosures by Hydro are intended to be installed by an experienced installer. If you need assistance with locating an experienced installer, contact us at 1.800.643.1514 or go to our website www.alumaxshowerdoor.com...
- Page 3 G03711103 Page 3 of 9 8-22-06...
- Page 4 The A Shower Enclosure LUMAX PEED TALL is completely reversible and may be installed pivot-left or pivot-right. For maximum waterproofing, the pivot jamb should be opposite the shower head. Using the diagram, determine the correct position for the door in your particular S installation.
- Page 5 Place the two wall jambs [E] into the ends of the curb assembly [A]. Plumb the jambs and mark the hole locations on the wall. Masking tape may be used to hold the curb in place during this operation. Remove all parts and drill the walls for mounting hardware.
- Page 6 Hold the two 135° posts [J] plumb and carefully measure horizontally from the top of each wall jamb [E] to the outside edge of the 135° post. Add 3/16" to each measurement to find the corresponding dimension on the header assembly (from the outside mitered edge to the squared ends) and trim the header assembly to fit.
- Page 7 Snap the fillers [P] into the curb assembly [A] and header assembly [D] between the door jambs with the raised lip to the exterior and the pivot holes toward the pivot jamb [M]. Center the curb filler in the curb between the pivot and strike jamb [N] (use masking tape to hold in position).
- Page 8 Insert the two nylon pivot bushings [Y] into the pivot holes in the head and curb fillers [P]. Lift the door panel [L] and insert the top pivot pin into the pivot bushing in the header filler. Hold the door vertical and insert the bottom pivot pin into the pivot bushing in the curb filler.
- Page 9 We recommend that you wait twenty-four hours before the first shower to allow the caulking to cure properly. To keep your Alumax Bath Enclosure looking like new we recommend the Alumax ShowerBright Consumer Maintenance Kit. The Consumer Maintenance Kit surface should be applied every 45 to 60 days.
Need help?
Do you have a question about the SPEEDSTALL 794S Series and is the answer not in the manual?
Questions and answers