Subscribe to Our Youtube Channel
Related Manuals for Alumax ProLine PL50
Summary of Contents for Alumax ProLine PL50
- Page 1 INSTALLATION INSTRUCTIONS ProLine PL50 FRAMELESS SLIDING ENCLOSURE Copyright © Alumax Bath Enclosures 2019. All rights reserved. G031047850 3-14-19...
- Page 2 INSTALLATION WARNINGS Alumax Bath Enclosures by Sapa are intended to be installed by an experienced installer. If you need assistance with locating an experienced installer, contact us at 1.800.643.1514 or go to our website www.alumaxshowerdoor.com...
- Page 3 Page 3 of 8...
- Page 4 Measure one of the glass Door Panels [A] and subtract 4 1/2”. That is the distance up from the sill that you will place the BOTTOM of the two Wall Mount Brackets [B]. Using a wall mount bracket as a guide, and holding it level, mark the hole locations on the walls, making sure that it is located so that the center guide can be installed properly in Step 5 of this instruction.
- Page 5 Set the header bar and stopper assembly into the wall mount bracket, from the top. Slide a Wall Mount Cover [G] into the wall mount bracket. Tighten the wall mount, and wall mount cover set screws [H] until the header bar is secure. This will prevent rattles in the header bar.
- Page 6 Place the two Bottom Seals [P] over the bottom of both door panels. One seal needs to be positioned with the sweep leg is on the same side as the roller. The other seal should be installed with the sweep leg on the side with the cap cover. Push the stoppers to the outside of the bar, on both ends.
- Page 7 For maximum water-proofing, the interior panel should always be positioned closest to the shower head, as shown in this illustration. The vinyl L Jambs [Q] are installed on the outside of both door panels. The walls need to be clean and free of any dust.
- Page 8 Insert the wrench (in the towel bar box) into the small hole on the edge of an end cap and rotate in a clockwise direction until tight. Repeat for all remaining end caps. Move the exterior panel until it just touches the L jamb on the side determined in step 10.
Need help?
Do you have a question about the ProLine PL50 and is the answer not in the manual?
Questions and answers