Table of Contents
Advertisement
BUTTON FUNCTIONS
1.
Check and make sure the plug voltage is by 120V, then plug in.
2.
When plugged in, the buzzer will beep, and the heater will enter the standby
mode, the power indicator will be on, and all other functions on display will
be off.
3.
When on standby mode, all keys will be invalid, except the
the
key and the device will start working. To turn the machine off, press
the power botton again and the device will start a countdown and switch
off. The default setting after it is turned on is shown below:
a.
The
b. The
4.
Once the unit is on and showing the default settings, press the
shift from low heating power to high heating power. If you press it again, it
will go back to the lower heating power.
a.
When the unit is operating at low heating power, the low heating power
indicator
indicator
b. When the unit is operating at high heating power, the high heating
power indicator
indicator
5.
After deciding the desired heating power
and temperature can be set. The
temperature on the unit. Once the timer and temperature are set, the
desired heating power will remain at the desired heating power in the
previous step. If the heating power needs to be changed from low to high or
high to low just press the
a.
By pressing the
to the default standby mode in five seconds) at this time you will be
indicates the low heating power
displays the default termperature
will show on the display and the high heating power
will not.
will show on the display and the low heating power
will not.
key once, the LED light will start flickering (It will go
http://www.NewAir.com
12
(low) or
key let you control the timer and
key once.
key. Press
key to
(high), the timer
Advertisement
Table of Contents
