Table of Contents
Advertisement
Snowy Picture, Poor Sound in TV
•
Check antenna/cable connection. Use new cable if
necessary.
Interference in TV
•
Check components for shielding, move away from
monitor if necessary.
RS-232C or LAN control is not available
•
Check RS-232C or LAN cable connection.
•
Check "CONTROL" setting in "EXTERNAL CONTROL".
•
Check the "ID=ALL REPLY" setting in "EXTERNAL
CONTROL".
The touch panel does not respond
•
Make sure that PIP mode is not selected.
•
Check the input signal setting.
•
Make sure that STANDBY setting in TOUCH PANEL in
ADVANCED OPTION is "ON".
•
Make sure that PC SOURCE setting in TOUCH PANEL in
ADVANCED OPTION is "AUTO".
•
Using slot 2 type PC: Make sure the slot 2 type PC is
connected properly.
•
Using external computer: Make sure the USB cable is
connected properly.
•
If the STANDBY setting in TOUCH PANEL in ADVANCED
OPTION is set to "ON", change it to "OFF" and back to
"ON" again.
•
When using touch function at the display edge, there may
be a slight gap between touch position on the screen and
where you touched.
It is the specifi cation and not a failure of product.
The response of the touch screen is not correct
•
Avoid direct sunlight or strong light on the screen.
•
If there are some obstacles near the TOUCH screen, it
may malfunction.
•
Sensor bar module may be dusty or dirty (see page 18,
Figure 1), wipe gently with a soft cloth.
The computer's power management does not work
•
It is recommended to choose "S1" at the "Power
Management" item in the BIOS (abbreviation of Basic
Input / Output System) computer's setup screen.
Either light vertical or horizontal stripes may appear, depending on the specifi c display pattern. This is no product fault or degradation.
English-43
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiSync V552-TM and is the answer not in the manual?
Questions and answers