Electrical Connection - Beko WTIK86151F User Manual

Adjusting Rear Feet
• When you turn the knob (visible in the circle)
in the direction of the arrow, the machine
will be elevated by 0.3 mm. When you turn
it in the opposite direction of the arrow, the
machine will be lowered by 0.3 mm.
• You can check your machine's rear
and front feet via water gage for correct
adjusment.
• Do not adjust the rear feet by using
chargeable devices. Use a screwdriver
instead.
Adjusting the feet with water level
• You must remove the Detergent Drawer to
set the Water Level.
• For the system to operate properly, the
bubble inside the Water Level must be in
the middle.
• If the bubble inside the Water Level is on the
left, the pre-set right foot of the Washing
Machine must be adjusted.
• If the bubble inside the Water Level is on the
right, the pre-set left foot of the Washing
Machine must be adjusted.
• If the bubble inside the Water Level is at
the back, the pre-set front feet of the
Washing Machine must be turned to the left
(clockwise).
9 / EN
• If the bubble inside the Water Level is at the
front, the pre-set front feet of the Washing
Machine must be turned to the right (anti-
clockwise).

4.1.7 Electrical connection

Connect the product to a grounded outlet
protected by a 13 A fuse. Our company shall
not be liable for any damages that will arise
when the product is used without grounding in
accordance with the local regulations.
• Connection must comply with national
regulations.
• The wiring for the electrical outlet circuit
must be sufficient to meet the appliance
requirements. Use of a Groud Fault Circuit
Interrupter (GFCI) is recommended.
• Power cable plug must be within easy reach
after installation.
• If the current value of the fuse or breaker
in the house is less than 13 Amps, have a
qualified electrician install a 13 Amp fuse.
• The voltage specified in the "Technical
specifications" section must be equal to
your mains voltage.
• Do not make connections via extension
cables or multi-plugs.
A
CAUTION!
• Damaged power cables must be replaced
by the Authorised Service Agents.
Electrical requirements
Before you insert the plug into the wall socket
make sure that the voltage and the frequency
shown in the rating label corresponds to your
electricity supply.
We recommend that this appliance be
connected to the mains supply via a suitable
switched and fused socket in a readily
accessible position.
Should the mains lead of the appliance
become damaged or need replacing at any
time, it must be replaced by a special purpose
made mains lead which can only be obtained
from a Authorised Service Agent.
B
WARNING!
• This appliance must be earthed
Washing Machine / User's Manual