Beko WTIK86151F User Manual page 10

If the fitted moulded plug is not suitable for
your socket, then the plug should be cut off
and an appropriate plug fitted.
Destroy the old plug, which is cut off as a
plug with a bared cord could cause a shock
hazard if inserted into a socket elsewhere in
the house.
The moulded plug on this appliance
incorporates a 13A fuse. Should the fuse need
to be replaced an ASTA approved BS1362
fuse of the same rating must be used. Do not
forget to refit the fuse cover. In the event of
losing the fuse cover, the plug must not be
used until a replacement fuse cover has been
fitted. Colour of the replacement fuse cover
must be the same colour as that visible on the
pin face of the plug. Fuse covers are available
from any good electrical store.
Important
Fitting a different plug
1 Connect the green - yellow or green (earth)
wire to the terminal in the plug marked 'E'
or with the symbol f or coloured green and
yellow or green.
2 Connect the blue (neutral) wire to the terminal
in the plug marked 'N' or coloured black.
3 Connect the brown (live) wire to the terminal
in the plug marked 'L' or coloured red.
With the alternative plugs a 13A fuse must be
fitted either in the plug or adaptor or in the main
fuse box. If in doubt contact a qualified electrician.
10 / EN
As the colours of the
wires in the mains
lead of this appliance
may not correspond
with the coloured
markings identifying
the terminals on your
plug, proceed as
follows:
Transportation of the product
1. Unplug the product before transporting it.
2. Remove water drain and water supply
connections.
3. Drain all water that has remained in the
product.
4. Install transportation safety bolts in the
reverse order of removal procedure.
C
INFORMATION!
• Never move the product without
the transportation safety bolts
properly fixed in place!
A
WARNING!
• Packaging materials are dangerous to
children. Keep packaging materials in a
safe place away from reach of the children.
4.1.8 Initial use
and Environment Instructions" and the
instructions in the "Installation" section.
To prepare the product for washing laundry,
perform first operation in Drum Cleaning
programme. If this programme is not available
in your machine, apply the method which is
described in the section 4.4.2.
C
INFORMATION
• Use an anti-limescale suitable
for the washing machines.
• Some water might have remained
in the product due to the quality
control processes in the production.
It is not harmful for the product.
Washing Machine / User's Manual
Before starting to
use the product
make sure that
the preparations
are made which
are in line with the
"Important Safety