HSS Hire 56410 Operating & Safety Manual

If the burner fails to light, turn the gas off at the
Operating & Safety Guide 541
cylinder and allow it to disperse before trying
again.
Once lit, hold down the gas relay button for about
30 seconds.
Hire Shops

EQUIPMENT CARE

Only use the heater for the purpose it was
designed for. Improper use may cause expensive
damage and could be dangerous.
If it will not do what you want, assume you have the
wrong equipment for the job. Contact your local HSS
Hire Shop for advice.
Keep the equipment clean. You will find less of a
chore if you clean it regularly, rather than wait until the
end of the hire period.
Handle gas bottles with care. Any protective plug
supplied must be fitted to the valve when not in use.
When not in use, store the equipment somewhere
clean, dry and safe from thieves.
Remember, propane regulators have a reverse
thread- turn them anti-clockwise to tighten, clockwise to
undo. To avoid damaging the thread, always fit the
regulator with its protective cap.

FINISHING OFF

Plaque & Box
Turn off the gas supply at the cylinder' s valve and wait
for the flame to die.
You can now disconnect the gas regulator ready for
Heaters
return.
Propane fired heaters for use in site
huts and small work areas.
Contact your local
0990 282828
©HSS Hire Service Group Plc 1996 No. 541/01
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Code 56410/56610