Operation - Swisher Trim-N-Mow Plus Owner's Manual

Trimmer line attachment positions:
•
Trimmer is equipped with 4 trimmer line attachment points.
•
When mowing with trimmer, the 4 trimmer line configuration is recommended for a more consistent, even cut.
•
When trimming tall or thick vegetation, the 2 trimmer line configuration is recommended for improved
performance.
To adjust cutting height:
1. Loosen set screw using hex wrench provided.
2. Slide cutting head up or down to desired cutting height.
3. Tighten set screw.
4. Any cutting height may be used with either trimmer line configuration.
4 Trimmer line Configuration
Shown set at Low cutting height
Important!
To ensure proper operation, clean the engine and trimmer regularly. Remove any build up
of chaff from the top of the engine. During operation debris may get wrapped around trimmer head.
Prolonged use in this condition may result in excessive wear and part failures. Periodically turn off trimmer
and remove debris.
To start the trimmer:
1. Remove any built up debris from engine and trimmer head.
2. Move throttle control to "FAST".
3. Push primer button on engine as directed.
4. Firmly grasp rope handle and pull out slowly until resistance is felt. Then pull back rapidly with a
full arm stroke. If engine fails to start after 3 pulls, repeat step 3.
5. When engine starts, leave throttle control at "FAST". Throttle control must be set in the fast
position for maximum performance.
6. Engage trimming head.
7. Begin trimming.
To engage/disengage trimmer head:
• Engage: Bring control bail into contact with the upper handle and grip it together with the handle.
If trimmer head does not fully engage, see belt adjustment section.
• Disengage: Release control bail. Trimmer head should stop within a few seconds. If it does not,
see belt adjustment section.
To stop the trimmer:
1. Release the control bail.
2. Move throttle control lever on engine to "SLOW" for a few seconds then move to "STOP".
Important!
For safest operation, make sure debris is directed away from you and others.
Trimmer Line Positions

Operation

7
2 Trimmer line Configuration
Shown set at High cutting height
Set Screw