Table of Contents
Advertisement
INSTALLATION
3.2 CONNECTING THE MR9 TO THE POWER SOURCE
To connect the repeater to the power source:
1. Plug the power cord (Figure 3-1) into the power receptacle
located on the side of the MR9.
2. Plug the power cord into a wall receptacle.
After you have made the power connection, verify that the PWR LED
is lit, indicating that the repeater is receiving power.
3.3 STRAIN RELIEF FOR THE POWER CORD
To eliminate the possibility of accidently disconnecting the MR9
power cord from the repeater, use one of the cable tie wraps to
anchor the power cord to the MR9 case. Figure 3-1 shows you how
strap the power cord to the tie down loop.
Power Cord
Tie Down Loop
Figure 3-1. Tying Down the Power Cord
Page 3-2
MR9T
802.3 10BASE-T
MULTI PORT REPEATER
LANVIEW
WITH
=
The Complete Networking Solution
X
PORT 9
8X
7X
Advertisement
Table of Contents
