Maintenance; Error Indicators And Warnings - Sharp HT-SBW125 Operation Manual

Troubleshooting chart (continued)
„ Condensation
Sudden temperature
operation in an extremely humid environment may
cause condensation inside the cabinet or on the
transmitter on the remote control. Condensation
can cause the sound bar to malfunction. If
this happens, leave the power on until normal
playback is possible (about 1 hour). Wipe off any
condensation on the transmitter with a soft cloth
before operating the sound bar.
„ If problem occurs during operation
When this product is subject to strong external
interference (mechanical shock, excessive static
electricity, abnormal supply voltage due to lightning,
etc.) or if it is operated incorrectly, it may malfunction.
If such a problem occurs, do the following:
1. Set the sound bar to the standby mode and turn
the power on again.
2. If the sound bar is not restored in the previous
operation, unplug and plug in the sound bar
again, and then turn the power on.
„ Factory reset, clearing all memory
Make sure to disconnect all output and input cables
attached to the sound bar before performing the
factory reset.
1. During standby mode, on the sound bar, press the
button.
2. Then, press and hold the
white, green and orange LED indicator light up
simultaneously.
Caution:
This operation will erase all data stored in memory.
changes, storage
button until

Maintenance

„ Cleaning the cabinet
or
Periodically wipe the cabinet with a soft cloth.
Caution:
z Do not use chemicals for cleaning (petrol, paint
thinner, etc.). It may damage the cabinet finish.
z Do not apply oil to the inside of each component.
It may cause malfunctions.

Error indicators and warnings

When you fail to perform operations properly, the
following messages are displayed.
On sound bar
Power indicator
(blinks red)
Note:
Should the same message appear even if the
sound bar is unplugged and plugged in, or is set
to the standby mode and on again, contact your
local dealer where you purchased the sound bar.
E-18
Meaning
z When the protection
circuit is activated.