Chapter 2 Oids To Enable/Disable Security; Introduction; Oids - Cabletron Systems LANVIEWsecure User Manual

2.1 Introduction

This chapter provides a list of the OIDs for LANVIEW

2.2 OIDs

The read-write community name for the Repeater MIB component is necessary to perform SNMP set
commands to enable/disable LANVIEW
community names. The examples shown below use the following definitions: b=board, p=port.
rptrSaTrapSetSrcaddr
Description:
Object Identifier:
Data Type:
Values:
Access Policy:
rptrSecurityLockState
Description:
Object Identifier:
Data Type:
Values:
Access Policy:
CHAPTER 2
OIDs TO ENABLE/DISABLE SECURITY
features. Refer to Chapter 4 for more information on
SECURE
{rptrSaTrapSet 1}
Enables and disables source address traps for this network.
1.3.6.1.4.1.52.4.1.1.1.4.1.6.2.1.0
Integer
1 disable
2 enable
3 other
read-write
{rptrSaSecurity 1}
Setting this object to Lock will activate the network port security lock. It is invalid to
set a value of portMisMatch(3). This value reflects a status value that the lock
status between the port group, port and repeater levels do not agree.
1.3.6.1.4.1.52.4.1.1.1.4.1.7.1.0
Integer
1 unlock
2 lock
3 portMisMatch
read-write
.
SECURE
2-1