Table of Contents
Advertisement
V
P
PD45/PH70
®
ISIONEER
ATRIOT
4.
Carefully angle the roller up and out of the scanner.
5.
Remove the replaceable roller from the bar.
6.
Discard the roller, it cannot be repaired or reused.
7.
Take the new roller out of its packaging. Clean any dust off the roller before installing it.
8.
Slide the new roller onto the bar. Make sure the struts on the bar line up to the slots in the end of the roller.
9.
Insert the round end of the roller into the slot in the scanner. Carefully lower the roller into the scanner. Make
sure the groove on the right side of the roller is aligned so that it slides in place into the U-shape of the
bracket.
44
M
AINTENANCE
S
U
G
CANNER
SER
UIDE
Advertisement
Table of Contents
