Table of Contents
Advertisement
Appendix B: EPIM Specifications
Receive
Sensitivity
Maximum
Receive
Input Power
Transmitter Power*
(At 25 C into
8.3/125 m fiber)
dBm
Less Power
* Transmit Power Typical Power
Coefficient
(See Note Below)-0.15dBm/
Parameter
Transmitter Peak
Wave Length
Spectral Width
Rise Time/
Fall Time
Duty Cycle
Bit Error Rate
The transmitter power levels given above are Peak Power Levels
after optical overshoot. You must use a Peak Power Meter to
NOTE
correctly compare the values given above to those measured on any
particular port. If you are measuring power levels with an Average
Power Meter, add 3 dBm to the average power measurement to
correctly compare the average power values measured to the values
listed above (i.e., -33.5 dBm average + 3 dB = -30.5 dBm peak).
B-4
Maximum Sensitivity (-36.0)
Typical Sensitivity (-31.0)
Minimum Sensitivity (-30.0)
-40
-35
-30
-25
Minimum Power
C
Typical
1300 nm
60 nm
3.0 nsec
2.5 nsec
50.1%
Better than 10
Maximum Transmit Power (-12.0)
Typical Transmit Power (-15.5)
Minimum Transmit Power (-21.0)
-20
-15
-10
-5
Maximum Power
-0.12 dBm/
C-0.18 dBm/
Minimum
1270 nm
-
2.7 nsec
2.2 nsec
49.6%
-10
Minimum Receive Input (-9.72)
Typical Receive Input (-7.5)
Maximum Receive Input (-6.99)
0
More Power
C
Maximum
1330 nm
100 nm
5.0 nsec
5.0 nsec
50.7%
Repeater MIM
Advertisement
Table of Contents
