Table of Contents
Advertisement
Chapter 3: INSTALLING THE RMIM
To place an RMIM into an unmanaged module group:
1. On only one RMIM, (even if more than one RMIM is to be in this group)
place the subnet jumper (JP8 on the TPRMIMs or JP4 on the CXRMIM and
FORMIM) in the ENABLE position as shown in Figure 3-1.
2. The jumper must be in the DISABLE position for any other MIMs included
in this unmanaged group.
3. Install the MIMs into the MMAC. The MIM with the subnet jumper enabled
in step 1 must be installed closest to the EMME or EMM-E6 as shown in
Figure 3-2.
You must install MIMs that are not in the unmanaged module group
closest to the EMME or EMM-E6. Install unmanaged MIMs next,
NOTE
followed by all non-repeater RMIMs. Figure 3-2 shows the correct
sequence.
Non-Repeater MIMs
Figure 3-2. Location of MIMs in the MMAC
3-4
Unmanaged Module Group
Subnet jumper set on this MIM only
Managed Repeater MIMs
Unmanaged MIMs
E
M
M
E
Repeater MIM
Advertisement
Table of Contents
