Table of Contents
Advertisement
Chapter 3: INSTALLING THE RMIM
3.2 SETTING THE RMIM JUMPERS
Each RMIM has two Ethernet jumpers and one Unmanaged Module Group
(Subnet) jumper.
Figure 3-1 shows the location and jumper number for each RMIM.
Ethernet Jumpers
JP1 (CXRMIM, FORMIM)
JP6 (TPRMIM-20/22/33/36)
ETH. B
ETH. C
ETHERNET JUMPER SETTINGS
ETH. B
ETH. C
Jumper Settings for operating
on Ethernet B (Default Setting)
UNMANAGED MODULE GROUP (SUBNET) JUMPER SETTINGS
SUBNET DISABLED
(DEFAULT SETTING)
3-2
JP2 (CXRMIM, FORMIM)
JP7 (TPRMIM-20/22/33/36)
STND ALONE
ETH. B/C
STND ALONE
ETH. B
ETH. B/C
ETH. C
Jumper Settings for
operating on Ethernet C
Figure 3-1. RMIM Jumper Configurations
Unmanaged Module Group
(Subnet) Jumper
JP4 (CXRMIM, FORMIM)
JP8 (TPRMIM-20/22/33/36)
SUBNET DISABLED
(FACTORY DEFAULT)
SUBNET B/C
STND ALONE
ETH. B
ETH. B/C
ETH. C
SUBNET ENABLED
STND ALONE
ETH. B/C
Jumper Settings for
Stand Alone Operation
Repeater MIM
Advertisement
Table of Contents
