Table of Contents
Advertisement
Connecting an AV receiver
or amplifier using an coaxial
digital audio cable
Player's rear panel
AC IN
Coaxial digital audio
cable (commercially
available)
Direction of signal flow
To coaxial digital
audio input terminal
AV receiver
or amplifier
Connecting components to
the USB port
About USB devices
The USB devices that can be connected to the
player are as shown below.
• USB 2.0-compatible USB flash drive
(capacity of 1 GB or greater, 2 GB or
greater recommended) or HDD (capacity 2
TB or less)
• File system: FAT16, FAT32 or NTFS
Notes:
• Devices formatted with a file system other
than the above cannot be used.
• USB devices may not be recognized if they
contain multiple partitions.
• Some USB devices may not operate with
this player.
• Operation of USB devices is not
guaranteed.
• BD-LIVE cannot be used with NTFS file
systems. Use it with FAT16 or FAT32.
White
L
COAXIAL
DIGITAL OUT
R
Red
AUDIO OUT
HDMI OUT
LAN (10/100)
2-channel analog
audio can also be
connected.
To audio
input
terminals
Connecting the USB device
Notes:
• Be sure to turn the player's power off
before connecting or disconnecting USB
devices.
• When using an external hard disk as the
external storage device, be sure to turn on
the hard disk's power before turning on the
player's power.
• If the USB device is write-protected, be
sure to disable the write-protection.
• When connecting the USB cable, hold onto
the plug, set the plug in the proper direction
for the port and insert it horizontally.
• Placing excessive loads on the plug may
result in poor contact, making it impossible
to write data on the USB device.
• When a USB device is connected and the
player's power is turned on, do not unplug
the power cord.
Player's front panel
USB
5 V
0.5 A
USB flash drive
Notes:
• Devices may not work if connected to the
USB port via a memory card reader or USB
hub.
• Use a USB cable with a length of 2 meters
or less.
STANDBY/ON
Hard disk, etc.
USB cable
(commercially
available)
15
02
Advertisement
Table of Contents
