Table of Contents
Advertisement
Flash-to-Pass
This feature allows the high-beam headlamps to be
used to signal the driver in front of you that you
want to pass.
Pull and hold the turn signal/multifunction lever toward
you to use this feature. When this is done the following
will occur:
•
If the headlamps are off, in low-beam or in
Daytime Running Lamps (DRL) mode, the
high-beam headlamps will turn on. They will
stay on as long as the lever is held there.
Release the lever to turn them off.
•
For vehicles with High Intensity Discharge (HID)
headlamps, the low-beam headlamps must be on
to activate the high-beam headlamps. See High
Intensity Discharge (HID) Lighting on page 5-58.
•
If the headlamps are already in high-beam mode,
they will remain on high-beam.
Windshield Wipers
The lever on the right side of the steering column
operates the windshield wipers.
Move the lever to one of the following positions:
7
(Mist): Pull the lever down and release it for a
single wiping cycle. The lever will return to its original
position. Hold the lever in this position for continuous
wiping cycles.
&
(Delay): For a delayed wiping cycle. Turn the delay
adjustment band to set the length of the delay.
3-9
Advertisement
Chapters
Table of Contents
