Spartan Clean on the Go User Manual page 5

INSTALLATION OF A MULTIPLE UNIT
STEP 1A
To install a multiple unit sys-
tem, start by installing the first
bracket on the wall as illustrat-
ed in Step 1. Then slide the
second bracket into the slot
from top to bottom on the left
side of bracket 1 until they are
properly aligned and secure.
Repeat step 1 for bracket two.
STEP 4A
Insert the unit connector
(#99097, sold separately) into
the first unit as illustrated.
STEP 2A
Unlock the left side of the first
system by pulling the rear clip
to its outward most position
as shown and remove the end
cap.
STEP 5A
Connect the second unit to the
first.
STEP 3A
Unlock the right side of the
second system by pulling the
clip to its outward most position
and remove the water connec-
tion.
STEP 6A
Apply the combined system
onto the bracket and complete
the installation as per step 3.