The Module Card Dip Switch - Cabletron Systems SmartSwitch 9500 Hardware And Installation Manual

Installing the 9A656-04 Module

The Module Card DIP Switch

An eight position DIP switch is located on the module card as shown in
Figure 2-3. The functions of the switches are listed in Table 2-1.
Do not toggle Switch 8 unless you intend to reset the user configured passwords
!
to their factory default settings.
CAUTION
Do not toggle Switch 7 unless you intend to reset the user parameters to the
factory default settings. Refer to the 9A656-04 Configuration Guide for
instructions on the parameters that may be configured by the user via
Local/Remote Management.
2-4
Table 2-1. Function of the DIP Switch
Switch Function
Clear
8
Password
Clear
7
NVRAM
Force BootP
6
Download
5 Reserved
4 Reserved
3 Reserved
2 Reserved
1 Reserved
Description
When toggled, this switch clears user-entered
passwords stored in NVRAM, and restores the
default passwords. Once reset you can use the
defaults or enter new passwords.
The module uses NVRAM to store user
entered parameters such as IP addresses,
device name, etc. To reset these parameters to
the factory defaults, toggle this switch. Once
reset you can use the defaults or enter new
parameters which are stored in NVRAM when
the module is powered down, and remain
there until the switch is toggled again.
Toggling this switch after pulling the board
out of the SmartSwitch 9500, clears download
information from NVRAM and forces image
files to be downloaded from the station
connected to the EPIM on the Environmental
Module configured to act as that modulesÕ
B P server.
OOT
For Factory Use Only
For Factory Use Only
For Factory Use Only
For Factory Use Only
For Factory Use Only