Crosley YTW4514 Owner's Manual & Installation Instructions page 19

CONNECT DRAIN HOSE TO
3
WASHER
Remove the cap from the drain port, if present, before
installing the drain hose .
Cap
Washer Back
Connect drain hose to drain port on back of washer . Open
clamp with pliers and slide onto hose end . Holding clamp
open, push hose end onto drain port until fully seated .
Release clamp between locating ribs on hose end . Outlet
of hose end should be oriented vertically .
49-3000223
Installation Instructions
Port
Drain
hose
Drain
port
Drain
end
Clamp
CONNECT WATER HOSES TO
4
WASHER
Unplug electrical cord before installing water hoses . If
not installed, install rubber washer in one end of hot
water hose . Thread hot water hose onto connection
labeled H at top rear of washer . Hand tighten and use
pliers to tighten hoses between 1/8 and 1/4 turn beyond
hand-tight .
If not installed, install rubber washer in one end of cold
water hose C . Thread cold water hose onto connection
labeled C at top rear of washer . Hand tighten and use
pliers to tighten hoses between 1/8 and 1/4 turn beyond
hand-tight .
Move washer as close to final location as possible,
leaving room for you to make water, drain, and electrical
connections to your home .
Rubber
washer
CONNECT WATER HOSES TO
5
OUTLET VALVES
Determine which is HOT water line before attaching
water hoses to faucets . Traditionally, HOT faucet is on
left .
(If screen washers are not installed) With protruding
part of screen toward you, install strainer screen/rubber
washer into each of the free ends of two water hoses .
Connect hot water hose to hot water
outlet valve of your home . Hand
tighten and use pliers to tighten
hoses between 1/4 and 1/2 turn
beyond hand-tight . Open hot water
valve .
Connect cold water hose to cold
water outlet valve of your home .
Hand tighten and use pliers to
tighten hoses between 1/4 and 1/2
turn beyond hand-tight . Open cold water valve .
Check for leaks and drips at the hose couplings . Tighten
as necessary .
Rubber
washer
19