Adjusting The Speakers (Balance/Fade) - Cadillac 2008 DTS Owner's Manual

a
Turn the knob clockwise or counterclockwise to
adjust the highlighted setting. The highlighted setting can
also be adjusted by pressing either SEEK arrow,
\ FWD (forward), or s
the desired levels are obtained. If a station's frequency
is weak or has static, decrease the treble.
To quickly adjust bass, midrange, or treble to the middle
position, press the pushbutton positioned under the
BASS, MID, or TREB label for more than two seconds.
A beep sounds and the level adjusts to the middle
position.
To quickly adjust all tone and speaker controls to the
middle position, press the
two seconds until a beep sounds.
EQ (Equalization): For the non-Bose
perform the following steps to setup the equalization
settings:
a
1. Press the knob until the equalization label
displays.
2. Press the pushbutton located under the equalization
label to get choices of POP, ROCK, CTRY (country),
TALK, JAZZ, and CLAS (classical), to display.
3. Press the pushbutton located under the desired
setting.
REV (reverse) button until
a
knob for more than
®
amplified radio,
®
For the Bose amplified radio, perform the following
steps to setup the equalization settings:
a
1. Press the knob until the DSP (Digital Signal
Processing) label displays.
2. Press the pushbutton located under the DSP label
to get choices of Norm, Driv, Rear, and Surround,
to display.
3. Press the pushbutton located under the desired
setting.
To select Surround, press either the fourth or fifth
pushbutton located under the displayed Surround
until Centerpoint displays.
To return to the manual mode, press the tune knob.
Select either BASS, MID, or TREB and start to manually
adjust the settings by turning the

Adjusting the Speakers (Balance/Fade)

BAL/FADE (Balance/Fade): To adjust balance or fade,
a
press the (tune) knob until the speaker control labels
display. Continue pressing to highlight the desired label,
or press the pushbutton positioned under the desired
a
label. Turn the knob clockwise or counterclockwise to
adjust the highlighted setting. The highlighted setting can
be adjusted by pressing either SEEK arrow,
or s REV buttons until the desired levels are obtained.
a
knob.
\
FWD,
3-103