Table of Contents
Advertisement
Read this first
1. Don't connect the wind turbine in the wrong polarity
Make sure you connect the +ve of the turbine to the +ve of the battery (red
to red) and the -ve of the turbine to the -ve of the battery (black to black).
Failing to do so will damage the equipment and invalidate your warranty.
2. Don't allow the turbine to run without being connected to the battery
Failing to do so will result in the turbine freewheeling causing premature
wear and tear and unnatural blade noise.
3. On arrival, ensure the main rotor is free turning
The stub shafts may have shifted in transit, causing the main rotor to rub
against the cowling as it turns. See instructions on page 8 to reset the stub
shaft positions.
4. Do not mount upside down
Cables are at the bottom of the turbine, not the top.
Visit our YouTube channel for assistance in wiring up the equipment,
configuring the DL-300 and run/stop switch and more.
Tel: +44 (0) 1981 241668
http://youtube.com/c/LeadingEdgeTurbines
Skyrrid Farm, Pontrilas, Hereford. HR2 0BW. UK
www.leadingedgepower.com
Rev K
Page 3 of 30
Advertisement
Table of Contents
