Memory - Medisana MTA 51005 Manual

GB
4 Operation / 5 Memory
4.3
Taking blood
pressure readings
4.4
Switching off
the unit
5.1
Displaying
stored results
5.2
Deleting memory
16
1. Switch the unit on by pressing the ON/OFF/START button
2. All the symbols on the display light up when the ON/OFF/START button
is pressed. This test can be used to check that the display is indicating
properly and in full. The display test disappears after approximately 1
second. The figure 0 appears briefly.
3. The unit is ready for measurement. It automatically inflates the cuff
slowly in order to measure your blood pressure. The pressure on the display
changes continuously during the time it continues to inflate.
4. The unit inflates the cuff until sufficient pressure has built up for a
measurement. Then the unit slowly releases air from the cuff and carries
out the measurement.
5. When the measurement is finished, the cuff is deflated completely. The
systolic and diastolic blood pressure and the pulse value with the pulse
symbol appear on the display
matically. The memory holds 60 measured values.
The unit has an automatic switch-off function. The unit switches off automa-
tically after a minute if no buttons are pressed.
The unit may also be switched off using the ON/OFF/START button
You can store up to 60 measurements (blood pressure and pulse) in the
memory of your blood pressure monitor. The measured values are stored auto-
matically. Press the MEMORY button
stored. The stored data appears on the display. The most recently measured
value is displayed first. Repeatedly pressing the MEMORY button
the respective values measured previously.
Should all 60 memory cells be occupied, the oldest value is deleted with a new
reading.
PLEASE NOTE
The saved measured values are retained even when the unit
is switched off.
Press and hold the MEMORY button
measured data stored will be deleted automati-cally.
. The measured values are stored auto-
to call up the measured values
for approximately 5 seconds and all
.
.
displays