Brother MFC-J1300DW Online User's Manual page 616

Level 1
Wired LAN
(MFC-J1300DW)
WLAN
Wi-Fi Direct
Level 2 Level 3
TCP/IP DNS Server
APIPA
IPv6
Ethernet -
Wired Status -
MAC Address -
TCP/IP BOOT Method
IP Address
Subnet Mask
Gateway
Node Name
WINS
Configuration
WINS Server
DNS Server
APIPA
IPv6
Setup Wizard -
WLAN Assistant -
WPS -
WPS w/ PIN -
Code
WLAN Status Status
Signal
SSID
Comm. Mode
MAC Address -
Push Button -
Level 4 Descriptions
- Specify the IP address of the primary or
secondary DNS server.
- Set the machine to allocate the IP
address from the link-local address
range automatically.
- Turn the IPv6 protocol on or off. For
more information, go to the Brother
Solutions Center at
to see FAQs & Troubleshooting.
- Select the Ethernet link mode.
- View the current wired status.
- View the machine's MAC address.
- Select the Boot method that best suits
your needs.
- Enter the IP address.
- Enter the Subnet mask.
- Enter the Gateway address.
- Enter the Node name.
- Select the WINS configuration mode.
- Specify the IP address of the primary or
secondary WINS server.
- Specify the IP address of the primary or
secondary DNS server.
- Set the machine to allocate the IP
address from the link-local address
range automatically.
- Turn the IPv6 protocol on or off. For
more information, go to the Brother
Solutions Center at
to see FAQs & Troubleshooting.
- Configure your wireless network settings
manually.
- Configure your wireless network settings
using the Brother installation disc.
- Configure your wireless network settings
using the one-button push method.
- Configure your wireless network settings
using WPS with a PIN.
- View the current wireless network
status.
- View the current wireless network signal
strength.
- View the current SSID.
- View the current Communication mode.
- View the machine's MAC address.
- Configure your Wi-Fi Direct network
settings using the one-button push
method.
support.brother.com
support.brother.com
609