Installing The Side Trim Strips; Preparing The Water Connection (A) - Beko DIT25401 Installation Manual

6.4 INSTALLING THE SIDE TRIM STRIPS

Remove the adhesive tape (Figure A).
Place the trim strips on the front edge of the side walls (Figure B).
NOTICE :
Make sure you use the correct trim strip since there is a left and right side strip. The
•
flexible material should be facing forward (Figure B).

6.5 PREPARING THE WATER CONNECTION (A)

Install an easily accessible shut-off valve (not supplied) in the water supply line. All solder
connections must be made before the water line is connected to the dishwasher's water
inlet valve. Water can also be supplied to the dishwasher by using a flexible braided hose
line.
Check with your plumbing supply sources for the proper hose and elbow and necessary
fittings for the water supply line. This material is not supplied, and must be purchased
separately.
Water Connection
11
USA