First Alert 7319DFB Operations & Installation Manual page 4

reMovinG tHe SaFetY interLocK Screw
IMPORTANT: Your safe may have a "Door Lock Override Device" installed.
This device is to prohibit the lock from locking and it must
be removed before the safe can be used properly.
Locate the handle spoke in the plastic bag and remove the
1
protective cover.
Screw in the handle spoke at the bottom of the handle hub.
Locate the Allen Wrench and the black cap in the plastic bag.
2
Locate the screw in the center of the Consumer
3
Warning label on the side of the door.
Loosen the screw with the Allen Wrench.
4
After the screw is removed, discard it and cover the hole with the black cap.
5
The Safety Interlock Screw must be removed before
BATTERY INSTALLATION AND PROGRAMMING THE LOCk.
5
Warning
batterY inStaLLation
important
keypad cannot be removed from door.
Locate the 9V Alkaline
1
Battery in the plastic bag.
Remove the Phillips head screw
2
from the battery cover located
on the bottom of the keypad.
Connect the battery and
3
gently insert the battery
up inside the keypad and
replace the battery cover.
Re-install the Phillips head
4
screw in the battery cover.
DO NOT OVER TIGHTEN!
6