Operating Instructions - Black & Decker BHDC201 Instruction Manual

SET UP & USE

OPERATING INSTRUCTIONS

Place the heater on a firm, level surface and plug the unit directly into a 120 V AC
electrical outlet.
NOTE: Only operate heater in upright position.
1. Turn the thermostat knob clockwise (right) direction until it reaches the maximum
setting (+). The knob needs to be turned past minimum setting (–) until you hear
a clicking noise in order to operate the Fan Only, "I" Low Heat or "II" High Heat
Settings.
2. Turn the heat control knob clockwise (right) from the OFF position to the FAN
ONLY, I (Low 750 watts) or II (High 1500 watts) Heat settings.
The power indicator light turns on when either the, FAN, LOW or HIGH setting is
selected.
When the desired temperature/comfort level is reached, lower the thermostat knob
until the heater stops operating. The thermostat will automatically maintain the
desired temperature level by cycling the heater on and off.
NOTE: Turning the TEMPERATURE control knob clockwise will increase the
temperature setting.
Turn the fan/heat control knob to "OFF" to shut off the unit.
Thermostat
Page 8
Fan/Heat control knob