Operating Instructions - Black & Decker BHTC301B Instruction Manual

SET UP & USE

OPERATING INSTRUCTIONS

Place the heater on a firm, level surface and plug the unit directly into a 120 V AC
electrical outlet.
NOTE: Only operate heater in upright position with caster wheels attached.
1. Powering Your Unit and Selecting the Desired Mode
or
or
2. Setting Desired Temperature
or
or
Page 10
Turn the heater on by pressing the ON/OFF button
on the control panel or by pressing the POWER
button on the supplied remote control.
NOTE: Once power is turned off, heating element will
stop working first. Fan will keep working for 1 min to
emit remaining heat inside.
Push MODE button on control panel or remote
control to select between high heat, low heat or fan
modes.
NOTE: High mode uses 1500W; Low mode uses
800W. When in "FAN", LED display will automatically
show the room temperature.
Adjust the desired temperature by pressing the
UP/DOWN buttons on the control panel or remote
control.
or
Desired temperature options vary from 59˚F to 86˚F
or from 15˚C to 30˚C. Once you have chosen the
desired temperature, the heater will remain on until
the room temperature increases to the temperature
on the digital display. The heater will cycle on and off
to maintain the desired room temperature.