NK TECHNOLOGIES AS1 - DODC - FL Instructions

Specifi cations
Power Required None - self powered
Output Switch Isolated Solid State Switch
Switch Rating DODC - N.O. 1A @ 30VDC
Off State Leakage <10 Microamps
Response Time 100 mS
Hysteresis < 8% of Setpoint
Set Point Ranges A Contact: Adjustable 0.75A - 20A
B Contact: Adjustable 0.75A - 20A
Start-up Delay 2.0 Seconds (fi xed)
Setpoint Adjust 4 Turn potentiometer
Isolation Voltage Designed to meet UL508 require-
ments to 1,270 VAC
Tested to 5,000 VAC
Frequency Range 6-100Hz
Sensing Apeture -FL 0.75" (19mm)
Environmental -4 to122Deg F (-20 to 50 Deg C)
0-95% RH, Non Condensing
Ranges & Maximum Amps
TYPE RANGE MAXIMUM INPUT AMPS
CONTINUOUS
FIXED CORE 0.75- 20 A 50A
FIXED CORE 20-50 A 50A
Model Number Key
AS1 - DODC - FL
OUTPUT
DODC - Dual Normally Open, 1.0A @ 30VDC
SENSOR TYPE:
AS1 - AC current operated switch with single range
0.75A -- 20A
AS2 - AC current operated switch with single range
20A -- 50A
Know Your Power
Other NK Technologies Products Include:
AC & DC Current Transducers
AC & DC Current Operated Switches
1φ & 3φPower Transducers
6 SEC. 1 SEC.
Current & Potential Transformers (CTs&PTs)
200A 400A
200A 400A
3511 Charter Park Drive, San Jose, CA 95136
800-959-4014 or +1-408-871-7510 Phone
+1-408-871-7515 FAX
sales@nktechnologies.com, www.nktechnologies.com
CASE STYLE:
FL - Fixed Core, Top Terminals
:
(Solid State Switch)
INSTRUCTIONS
AS1 DODC SERIES
AC Current Operated Switch
With Dual Output
Quick "How To" Guide
1. Run the wire to be monitored through
aperture.
2. Mount the sensor.
3. Connect output wiring.
A. Use up to 14 AWG copper wires.
B. Ensure load matches the output shown on
the sensor label.
4. Adjust Setpoint
A. Use the potentiometer to adjust the set-
point.
AS1-DODC-FL Inst. Rev 2 12/14 P/N 39-360-0001