Table of Contents
Advertisement
4-1. Fuse replacement
Disconnect and remove all connections from any live power source.
Unscrew fuse holder by screw driver.
Locate the defective fuse and remove it by gently pulling-out.
Install a new fuse of the SAME SIZE AND RATING.
Screwing fuse holder.
MAKE SURE THAT THE RATED AND SPECIFIED FUSES ARE USED FOR
REPLACEMENT.
4-2. Adjustment and calibration
It is recommendable to regularly adjust and calibrate this instrument. Qualified and
authorized personnel only should execute performance and procedures
4-3. Cleaning and decontamination
The instrument can be cleaned with a soft clean cloth to remove any oil, grease or
grime. Never use liquid solvents or detergents. If the instrument gets wet for any
reason, dry the instrument using low pressure clean air at less than 25 PSI. Use
care and caution around the window cover areas where water or air could enter into
the instrument while drying.
5. OTHERS
5-1. Introduction
Because of the great versatility of this Sweep/Function Generator, it would be
impossible to include all of its possible applications in this manual, However ,many
of the primary applications are described in detail to allow the user to adapt the
procedures to other applications. The instrument has vast numbers of applications
as a signal source in electronics design labs, classrooms, service shops and
production facilities to test or analyze audio, radio, digital, communications, medical
electronics, sonar, industrial electronics, subsonic, ultrasonic and many other
electronic devices and circuits.
CAUTION
Advertisement
Table of Contents
