Starting The Engine - Generac Power Systems R100 Operator's Manual

Table of Contents

IV. Starting the Engine

1. Turn the choke lever to the "CHOKE" position. If the engine is hot from use, leave

the choke lever in the "RUN" position.

2. Move throttle lever to the left a little.

3. Starting the engine

Turn the engine switch to the "ON" (START) position.

b. Pull the recoil starter grip lightly until resistance is felt, then pull briskly.

Don't allow the recoil starter grip to snap back against the engine. Return it gently to prevent damage to the starter

Choke Lever

CHOKE

RUN

Throttle Lever

High Speed

Manual Engine Switch

Low Speed

OFF

Recoil

Starter

Grip

Table of Contents

Do you have a question about the R100 and is the answer not in the manual?