Advertisement
2.3 Powering On and Off + Main Status LED
To power your camera on, press the power button for 4 seconds. The
camera will begin to initialize and power on. The total initialization time
is 9 seconds. Once the camera emits 2 sets of audible beeps, the
camera is ready for use. To power your camera off, press the power
button for 4 seconds until the camera emit 3 beeps. You can then
release the power button.
The powering on/off sequence was designed this way to prevent
accidental recording and battery drain while the camera is packed away
in your bag or pocket.
The camera's main status LED is located on the front of the camera,
above the power button. This LED is for displaying the camera's overall
state. Below is a chart describing each of the LED's colors and state.
LED COLOR
No Color
GREEN solidly illuminated
GREEN fast flashing
GREEN slow flashing
GREEN singe flash
GREEN & ORANGE flash
2.3.1 Enabling Wi-Fi and Wi-Fi Status LED
Enabling Wi-Fi will allow you to connect your camera to your
smartphone. To enable the Wi-Fi function on your camera, ensure your
camera is powered on and press the Wi-Fi button located on the side of
your camera for 2 seconds. The Wi-Fi's status LED will begin
illuminating BLUE. To disable the Wi-Fi function, press the Wi-Fi button
for 3 seconds until the camera emits an audible beep.
The Wi-Fi status LED is located on the side of the camera body, above
the Wi-Fi button. This LED is for displaying the Wi-Fi's overall state.
Below is a chart describing each of the LED's colors and state.
LED COLOR
No Color
BLUE fast flashing
BLUE slow flashing
BLUE solidly illuminated
BLUE double flash loop
RED flashing
FUNCTION
Camera is powered off
Camera is ready to capture; standby
Insert MicroSD card
Video is being recorded
Photo was captured
Battery charge is running low
FUNCTION
Wi-Fi is disabled
Wi-Fi is enabled
Wi-Fi is waiting to be connected
Wi-Fi is connected to smartphone app
Camera is entering Live Streaming
Live Streaming mode is enabled
Advertisement
