EnGenius EL-2611CB3+ User Manual page 8

Reboot bridge - After you have made changes through any of the screens, click
this button to enable the new settings.
Reset to factory defaults - Resets all configuration settings to their default
values.
Switch to AP – Change the Client Bridge mode to the AP mode.
To clear any values you've entered on any page, click the Cancel button. To apply any
settings you've altered on any page, click the Save button. After you change any
settings, it is necessary to reboot the client bridge for the new settings to take effect.
3.2.5 Stations
This page shows the list of the information including the IP address and the MAC
address of the stations which are being connected to the client bridge.