EnGenius EL-2611CB3+ User Manual page 7

3.2.3 Admin
IP Information Settings
You can change the IP address, Subnet Mask and Default Gateway of the Client
Bridge manually by selecting Static in the IP Address Mode. If you select DHCP in
the IP Address Mode, the Client Bridge can get TCP/IP parameters from the DHCP
server on your network.
Allow upgrade uploads means you are allowed to upgrade the firmware of the
Access Point using TFTP utility. Check the box to enable this function.
IP Address Mode - Enables you to select the IP address mode: Static or DHCP
(Dynamic Host Configuration Protocol). DHCP mode enables the DHCP server on
your network to override the current IP address settings.
IP Address - Sets the Bridge's IP address.
IP Subnet - Sets the Bridge's Subnet Mask address.
IP Gateway - Sets the IP address of your network's Gateway.
Device Name - Sets the Bridge's name. The default name is blank.
Allow Firmware Upgrade - When the box is checked, the Bridge accepts
firmware upgrades.
Cloning bridge - Use this option to enable MAC cloning. Bridge will set the
wireless interface to use the MAC address of a device from the wired side. Multiple
devices can be connected but only the first device will be cloned. This is required
for special networking situations, eg. XBox, or some IPX device networking.
Administration
On this page, you can also change the login user name and administrator
password, reboot the client bridge, reset all settings to the factory default,
and switch the client bridge to AP mode.
Change user name - Set or change the user name required to access the utility.
The default user name is blank.
Change password - Set or change the network password required to access the
utility. The default password is blank.