EnGenius EL-2611CB3+ User Manual page 6

mode you need to implement.
The SSID (Service Set IDentifier): A unique name setting in the Access Point
which the client bridge wants to connect to in the point to point mode or shares
among all points in the ad-hoc mode. The SSID must be identical for each point in
the wireless network and is case-sensitive. Leaving the field blank means that
using "any" to connect to the Access Point having the strongest signal received by
the client bridge in point to point mode.
Channel: the shared channel among all points in point to point mode. The
permissible channels depend on the Regulatory Domain.
Transmission rate (M bits/s): Select and define all the supported rates ( 1、
2、5.5、11 M-bit/s) at which the client bridge will communicate with the Access
Point in point to multi-point or other client bridges in point to point mode. You can
also leave it to the default (automatic) to let the client bridge decide which data
rate to use.
Access Point Density: select the three different rates (high, medium, low) to
scan the Access Points in your wireless network.
WEP configuration: An acronym for Wired Equivalent Privacy. WEP is an
encryption method used to protect your wireless data communications. WEP uses
a combination of 64-bit or 128-bit keys to provide access control to your network
and encryption security for every data transmission. To decode a data
transmission, each point in a network must use an identical 64-bit or 128-bit key.
Higher encryption levels mean higher levels of security, but due to the complexity
of the encryption, they may mean decreased network performance. For 64-bit
keys, you must enter 10 hex digits (0-9; A-F) (ex: 12345ABCDE) into the four
key boxes. For 128-bit keys, you must enter 26 hex digits (ex:
1234567890ABCDEF1234567890) into the key box. If you leave a key box blank,
that means setting this key to all zero.
WEP Enabled: In order to utilize WEP encryption, please click the checkbox. If
you do not wish to utilize WEP encryption, leave the checkbox blank.
WEP key lengths: Select 64-bit or 128-bit key you want to use.
WEP key to use: Select which set of key you want to use for transmitted data.
To clear any values you've entered on any page, click the Cancel button. To apply any
settings you've altered on any page, click the Save button. After you change any
settings, it is necessary to reboot the client bridge for the new settings to take effect.