EnGenius EL-2611CB3+ User Manual page 12

Admin
IP Information Settings
You can change the IP address, Subnet Mask and Default Gateway of the Access
Point manually by selecting Static in the IP Address Mode. Or you can select DHCP
in the IP Address Mode. The Access Point can get the TCP/IP parameters from the
DHCP server on your network. You don't have to set up them manually.
IP Address Mode - Enables you to select the IP address mode: Static or DHCP
(Dynamic Host Configuration Protocol). DHCP mode enables the DHCP server on
your network to override the current IP address settings.
IP Address - Sets the AP's IP address.
IP Subnet - Sets the AP's Subnet Mask address.
IP Gateway - Sets the IP address of your network's Gateway.
Device Name - Sets the AP's name. The default name is blank.
Allow upgrade uploads means you are allowed to upgrade the firmware of the
Access Point using TFTP utility. Check the box to enable this function
On this page you can change the login user name and administrator password, reboot
the Access Point, or reset all settings to the factory default. After you change
any settings, it is necessary to reboot the Access Point for the new settings to take
effect.
Administration
On this page, you can also change the login user name and administrator
password, reboot the AP, reset all settings to the factory default, and switch
the AP to the client bridge mode.
Change user name - Set or change the user name required to access the utility.
The default user name is blank.
Change password - Set or change the network password required to access the
utility. The default password is blank.
Reboot bridge - After you have made changes through any of the screens, click
this button to enable the new settings.
Reset to factory defaults - Resets all configuration settings to their default
values.
Switch to bridge – Change the AP mode to the Client Bridge mode.
To clear any values you've entered on any page, click the Cancel button. To apply any
settings you've altered on any page, click the Save button. After you change any
settings, it is necessary to reboot the client bridge for the new settings to take effect.