Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for BROSA Orion Floor Lamp
Summary of Contents for BROSA Orion Floor Lamp
- Page 1 Orion Floor Lamp A S S E M B LY G U I D E...
- Page 2 F O R Y O U R S A F E T Y Lift, don’t drag. This protects Check the assembly guide your floor and product. for required components. Assembly requires 2 people. Assembling this product on It's always easier with a a soft surface protects its friend.
- Page 3 Safety MAX.40W 220-240V ~ 50Hz 1. For indoor use only. 2. Follow instructions carefully. Any deviations may be hazardous, or void your warranty. 3. The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire shall be destroyed. 4.
- Page 4 Components Before you get started, check you have all of the pieces below. If anything’s missing, we’ll sort it out right away. Simply visit: www.brosa.com.au/pages/product-return-and-parts-request ② ① Stand x 1 Shade x 1 ③ Base Plate x 1 ④ Base Weight x 1...
- Page 5 Step 1 Unscrew the bolts and nuts with the spanner and remove them from the joint along with the flat washers. Keep the removed parts for the following assembly.
- Page 6 Step 2 Re-arrange the cable as shown in the diagram below. Fit the lower part of stand into the joint. Fit the parts removed in Step 1 back to the joint again and then tighten them with the spanner B.
- Page 7 Step 3 Unscrew the nut from the bottom of the stand with the spanner B. Remove the nut along with the spring washer and flat washer. Keep the removed parts for the following assembly.
- Page 8 Step 4 ③ Align the base plate with the rods on the bottom of the stand followed by the base weight ④ and make sure the long rod protrudes from the bottom of the base weight. Fit the flat washer onto the rod followed by the spring washer and then the nut.
- Page 9 Step 5 Unscrew the nut from the top of the stand using the spanner B.
- Page 10 Step 6 ② Attach the shade to the top of the stand and make sure the rod protrude from the brace. Fit the nut removed in Step 5 to the rod and tighten it with the spanner B. ②...
- Page 11 Step 7 Unscrew the shade ring and remove it from the bulb holder. Unscrew the bolts that fasten the bottom shade panel with the Allen key A. Remove the bottom shade panel and the bolts and place them aside for the following assembly.
- Page 12 Step 8 Lead the bulb holder through the hole on the top of the shade and make sure it fits into the bracket inside the shade.
- Page 13 Step 9 Attach the shade ring to the bulb holder again and screw it until the bulb holder is tight and secure. Gently screw the correct bulb (not included) into the bulb holder.
- Page 14 Step 10 Align the bottom shade panel with the bottom of the shade again and fix it in place with the bolts removed in Step 7 and Allen key A.
- Page 15 Step 11 Direct the light where you want it as the light arm and shade are adjustable. Enjoy! We hope your new Orion Floor Lamp lights up your life!
Need help?
Do you have a question about the Orion Floor Lamp and is the answer not in the manual?
Questions and answers