Chevrolet Corvette C8 2021 Manual page 10

PAGE-4
SETUP- (UNIVERSAL GARAGE REMOTE) MEMORY
SETUP
(UNIVERSAL REMOTE)
**P-102 (Owners)
USING
(UNIVERSAL REMOTE)
**P-104 (Owners)
ERASING
(UNIVERSAL REMOTE)
**P-104 (Owners)
REPROGRAM
(SINGLE BUTTON)
(UNIVERSAL REMOTE)
**P-104 (Owners)
NORMAL OPS
SETUP- (UNIVERSAL GARAGE REMOTE) MEMORY
NOTE-
This system can replace up to three remote control transmitters used to

activate devices such as garage door openers, security systems, and home
automation devices.
 Park outside directly in line with and facing the garage door
opener receiver.
 Make sure the hand-held transmitter has a new battery for quick and
accurate transmission of the radio-frequency signal.
PROGRAM VEHICLE (UNIVERSAL REMOTE)-
1- Hold the end of the (Hand-Held Transmitter) about 3 to 8 cm (1 to 3 in)
away from the Vehicle Universal Remote system.
2- Press & Release one of the Car Remote Buttons.
3- At the same time, press and hold both the hand-held transmitter button
and one of the three Universal Remote system buttons to be used to
operate the garage door. Do not release either button until the indicator
light changes from a slow to a rapid flash. Then release both buttons.
4- Press and hold the newly programmed Universal Remote system button for
five seconds while watching the indicator light and garage door activation.
While watching the indicator light and garage door activation.
If the indicator light stays on continuously or the garage door moves when

the button is pressed,- then programming is complete.
If the indicator light does not come on or the garage door does not move, - a

second button press may be required. For a second time, press and hold the
newly programmed button for five seconds. If the light stays on or the
garage door moves, programming is complete.
 If the indicator light blinks rapidly for two seconds, then changes to a solid
light and the garage door does not move, - continue with programming
Steps 4–6.
4- After completing Steps 1–3, locate the Learn or Smart button inside the
garage on the garage door opener receiver.
5- Press and release the Learn or Smart button. Step 6 must be completed
within 30 seconds of pressing this button.
6- Inside the vehicle, press and hold the newly programmed Universal Remote
system button for two seconds and then release it. If the garage door does
not move or the lamp on the garage door opener receiver does not
flash, press and hold the same button a second time for two seconds, then
release it. Again, if the door does not move or the garage door lamp does
not flash, press and hold the same button a third time for two seconds,
then release it.
1- Press and hold the appropriate Universal Remote system button for at least
one-half second.
2- The indicator light will come on while the signal is being transmitted.
1- Press and hold the two outside buttons until the indicator light begins to
flash. This should take about 10 seconds
2- Release both buttons.
1- Press and hold any one of the buttons. Do not release the button.
2- The indicator light will begin to flash after 20 seconds. Without releasing the
button, proceed with Step 1 under "Programming the Universal Remote
System."
12-12-20