Hitachi BD-90YCV Operating & Installation Instructions Manual page 26

Connecting the
water supply
26
How to Install the Washing Machine
● Water supply hose
■
Optimum water pressure is 0.03-0.8MPa.
■
Do not connect to the mixer tap of an unpressurised hot-water
apparatus.
■
Use a horizontal tap.
Horizontal tap
* Model with SCREW TYPE water supply hose.
min. 10 mm
* Model with ONE TOUCH JOINT water supply hose.
1. Untighten the upper connector
screw.
Upper connector
Fixing screw
●
In case the diameter of the tap
is large, remove the guide plate.
Guide plate
3. Connect the water supply
hose to the middle connector,
pushing the plate down.
Middle connector
Water supply hose
Extension tap
Connect the water supply hose to the rear panel of
the washing machine.
Make sure that the rubber seal is inside the hose
connector.
Hose connector
Firmly connect the water supply hose to the tap, and
check connection points for water-tightness.
2. Push the upper connector up
till the rubber packing is in
tight contact with the tap. Then
Rubber packing
tighten the 4 screws.
Middle
connector
Upper connector
●
Turn the middle connector so
that there is no water leak.
Connector
●
To separate the water
supply hose from the middle
connector, turn off the tap, and
then pull the inlet hose down,
pushing the plate down.
Square tap
Rubber seal
Rubber packing
Middle connector