Advertisement
Hanging the Fan
to turn off the power. Follow
REMEMBER
the steps below to hang your fan properly:
CAUTION
REMOVE 3 RUBBER PACKING MOUNTS AND
DISCARD BEFORE INSTALLATION.
Step 1. Remove the decorative canopy
bottom cover from the canopy by turning the
cover counter clockwise.(Fig. 5)
Step 2. Remove the hanger bracket from the
canopy by loosening the two screws on the
bottom of the hanging bracket
from the screw head and turning the canopy
counter clockwise.(Fig, 5)
Step 3. Pass the 120-volt supply wires
through the center hole in the ceiling hanger
bracket as shown in Fig. 6.
Step 4. Secure the hanger bracket to the
ceiling outlet box with the screws and
washers provided with your outlet box.
Step 5. Remove the hanger pin, lock pin and
set screws from the top of the motor
assembly.
Step 6. Route wires exiting from the top of
the fan motor through the collar cover,
canopy cover, canopy and then through the
ball / downrod. (Fig. 7)
Step 7. Align the holes at the bottom of the
downrod with the holes in the collar on top of
the motor housing (Fig.7). Carefully insert
the hanger pin through the holes in the collar
and downrod. Be careful not to jam the pin
against the wiring inside the downrod. Insert
the locking pin through the hole near the end
of the hanger pin until it snaps into its locked
position, as noted in the circle inset of Fig. 7.
FAILURE TO PROPERLY INSTALL LOCKING PIN
AS NOTED IN STEP 7 COULD RESULT IN FAN
LOOSENING AND POSSIBLY FALLING.
Step 8. Tighten two set screws on top of the fan
motor firmly (Figure 7)
a half turn
Step 9. Place the downrod ball into the hanger
bracket socket.
Figure 5
WARNING
Hanger
bracket
Ceiling
canopy
Canopy
cover
CUL Listed
electrial
box
Hanger
bracket
Hook
120V Wires
Figure 6
Motor wires
Ball/downrod
assembly
Canopy cover
Collar cover
Hanger pin
Figure 7
Washers
Mounting
screws
(supplied with
electrical box)
Downrod
Canopy
Set screws
Locking
pin
4.
Advertisement
