Advertisement
Restore power to the ceiling fan and test
for proper operation.
1. "HI, MED, LOW" buttons:
These three buttons are used to set the fan
speed as follows:
LOW=Low speed MED= Medium speed
HI=High speed
2. "FAN OFF" button:
This button turns the fan off.
3.The "LIGHT" button turns the light ON or
OFF and also controls the brightness setting.
Press and release the button to turn the light
ON or OFF. Press and hold the button to set
the desired brightness. The light key has an
auto-resume, it will stay at the same
brightness as the last time it was turned off.
HI
MED
LOW
FAN OFF
OFF
Figure 20
4. The Slide "OFF-ON" button turns all power
off-on to fan and light.
Speed settings for warm or cool weather depend
on factors such as the room size, ceiling height,
number of fans, etc.
The Reverse switch is located on the top of
motor assembly. Slide the switch to the Left
for warm weather operation. Slide the switch
to the Right for cool weather operation.
NOTE: Wait for fan to stop before changing
the setting of the slide switch.
Warm weather -
flow creates a cooling effect as shown in Figure
21. This allows you to set your air conditioner on
a higher setting without affecting your comfort.
Cool weather - (Reverse) An upward airflow
moves warm air off the ceiling area as shown in
Figure 22. This allows you to set your heating
unit on a lower setting without affecting your
comfort.
ON
Operating the Transmitter 12.
(Forward) A downward air
Figure 21
Figure 22
Advertisement
