Table of Contents
Advertisement
To register a design in the memory of the machine
3-2-3.
How to operate (to use bar code reader)
The following is an example when registering a design (stored in a personal computer) into the memory of
the machine.
(1)
After connecting the LAN cable to the LAN port at the back of the operation panel, start up DG/ML by
Pulse.
(2)
Check if network setting is "YES" (p.180).
(3)
Connect the bar code reader to the USB port of the operation panel (p.19).
(4)
To set to main screen
(5)
To read bar code
Condition data (color change order) is also read automatically.
Bar code
This design has become the state that it is possible to embroider (Data set is completed).
After that, proceed to "To change color automatically / to start operation automatically (Auto Color
Change "AC / Auto Start "AS") (p.53)".
PT10R
TAJIMA_W
14117
Please buy a commercial item.
Reading of the bar code is also possible from
the following screen.
1 Data Input (Memory)
A
4 Data Input (USB)
5 Data Input (LAN)
0
Bar codes can be printed by the print
function of DG/ML by Pulse.
Chapter 4
1
2
3
4
5
6
7
8
9
10
11
45
Advertisement
Table of Contents
