Table of Contents
Advertisement
Necessary works after replacing the frame
To set frame type to "Auto Clamp" for single-head machine, follow the procedure below.
To execute "Frame Origin Memory", follow the procedure below. The frame could hit the
machine depending on the frame position and it might cause the damage of the parts.
RR07
Frame origin memory
is executed.
"YES" >> SET
STOP
Press STOP switch
immediately after moving
the frame.
Press E key.
Move the frame to the upper
right position from the center of
embroidery space by manual
frame travel.
!
CAUTION
If the SET key is pressed, the frame will
move.
Press STOP switch immediately after
moving the frame.
Perform operation of "Frame Origin
Memory". (SET+F2)
Upper right position
Center of the embroidery space
Code No.5C1 will appear.
Chapter 6
1
2
3
4
5
6
7
8
9
10
11
143
Advertisement
Table of Contents
