Operation; Switching On And Off; Manual Fog Output - EuroLite NSF-250 User Manual

6

OPERATION

The built-in control panel on top of the machine features four operating buttons and a display which shows all
operation statuses of the machine. The control panel allows the user to customize the color of the LEDs and
configure the fluid sensor. It is possible to operate the machine manually with the button MANUAL FOG at
the control panel or via the wireless remote control.

Switching on and off

1
Switch on the machine with the power switch (lights up). The machine will heat up for approx.
5 minutes and "HEAT" is indicated in the display.
2
While the unit is warming up, fog output will not be possible yet. Once the warm-up process is
completed, "HEAT" will no longer be indicated in the display and the machine is ready to emit fog.
3
After operation, switch off the machine with the power switch.
The output nozzle will heat up during operation. Therefore do not touch the nozzle until it has
cooled down completely!
Prior to transportation, allow the machine to cool down and completely empty the tank.
Never operate the fog machine without fog fluid. Fire hazard due to overheating! Besides, the
unit may be damaged.
During operation smoke emission may stop. In this case the device is heating up again. After a
short period, the machine will be ready to emit fog again. This process guarantees an
appropriate vaporization temperature and the best fog emission possible. The temperature is
regulated by a high-quality thermostat.

Manual Fog Output

To manually activate a fog output, press the green MANUAL button. While this switch is kept pressed, the
unit will emit the maximum amount of fog. As soon as you release the button, the fog output will stop. In
manual mode, the LEDs do not light.
Wireless Remote Control
With the remote control it is possible to activate the fog output and the LEDs via radio over a distance of up
to 25 meters. The remote control's buttons 1 to 4 trigger the options set in color menus CH-1 to CH-4.
1
For operation, put the antennas at the fog machine and the remote control in a vertical position.
2
When you hold down any of the four trigger buttons, the fog machine will emit the maximum amount of
fog and activate the color setting assigned to the button.
3
As soon as you release the button, the fog output will stop and the LEDs go out.
Note: If a color menu is set to oFF for any trigger button, the machine will emit fog and without activating the
LEDs when this button is pressed.
www.eurolite.de
19