Programming The Autodialer Functions; Programming Contact Telephone Numbers - Temperature Guard VM605 Manual And Installation Instructions

Programming the Autodialer Functions

Accessing the Program Menu
From the Main Menu, press 3.
► The "Full Access" PIN will be requested if the "Acknowledge Only" PIN
was entered initially. If the correct "Full Access" PIN is not entered, the
Guard will hang up.
Option
1
2
3
4
5
6
7
8
9
*
#
0
Programming Contact Telephone/Pager Numbers
The Guard stores up to eight (8) contact telephone or pager numbers.
1) From the Program Menu, Select 1 to set telephone numbers.
2) You will hear "Select contact."
3) Select 1 for the first contact number, 2 for the second contact number, 3 for the third contact
number, or 4 for the fourth contact number etc.
► Press 0 to return to the Program Menu.
4) You will hear "Contact x is xxxxxxx" or "Contact x is Empty, press one to change."
5) Press 1 to make a change.
6) You will hear "Enter number followed by the # key."
7) Enter the number, followed by a #.
► For pager numbers, enter * as the first digit of the number.
► Enter the full telephone number (1 + area code if necessary).
► If an extra delay between digits or after dialing is required, entering * will provide a two second
delay. Do not enter * for the first digit unless programming a pager number.
8) Entering only the # key will erase the currently programmed contact telephone number.
9) You will hear the telephone number you just entered.
10) You will be prompted to select another contact to program.
► Press 0 to return to the Program Menu.
Program Menu
Function
Program Contact Telephone Numbers
Program Local ID Number
Record Unit ID Message
Program Number of Rings
Change "Full Access" PIN
Program Reminder Calls
Program Repeat Warning Messages
Set Temperature Readout Units (°C or °F)
Program Power Outage Time Delay
Change Unit Callout Time Delay
Change "Acknowledge Only" PIN
Exit (return to Main Menu)
10
NOT SPOKEN
NOT SPOKEN
NOT SPOKEN
NOT SPOKEN
NOT SPOKEN
NOT SPOKEN